Elios 2 Remote controller is beeping and red LED flashes

A beeping sound and red flashing LED can indicate the following errors:

• Low battery

• Stick calibration

• Hardware error

If the possibility of a low battery has been eliminated then the use of the "DJI GO" app is required the debug the issue further.

As DJI GO and Elios Cockpit don't get along , we do not recommend you to install it on the Flyability tablet. We recommend installing DJI GO on your personal device, such as smartphone or tablet.

---

Important notice

firmware version of the controller must remain at version 1.2.10

As DJI GO and Elios Cockpit don't get along , we do not recommend you to install it on the Flyability tablet. We recommend installing DJI GO on your personal device, such as smartphone or tablet.

---

What you will need

• Android/IOS device with DJI GO app installed (DJI GO—for products before P4 version) DJI Go App (Android/IOS)

• USB Cable

• The remote controller

---

Step by Step guide

• Deploy, connect the USB cable and turn on the GCS.

• Launch DJI GO app

• Once the Remote Controller Picture appears, tap on Camera.

• Tap on the bar at the top of the screen to display the cause of the error.

1. If calibration is required: follow the on screen instructions to perform the calibration. Instruction are detailed in this articles

2. If hardware error: The unit will need to be sent to Flyability for repairs or swapped out for a new unit. Please contact the support